100% of 100
In stock

Made in the USA by Class D audio 300W RMS Stereo, 600W RMS Bridged, Balanced Inputs, 2 Ohm Stable Our newest audio power amplifier is based on the Texas Instruments new TAS5630 digital amplifier chip.

You have submitted no questions.
Ask Your Question
Jot us a note and we’ll get back to you as quickly as possible.
This audio power amplifier is based on the Texas Instruments TAS5630 digital amplifier chip, a high-performance, integrated stereo feedback, analog-input, digital amplifier with a power stage designed to drive 2-Ω to 8-Ω speakers at up to 300 W per channel in stereo, or up to 600W bridged. This amplifier requires only a single 20V to 50V power supply to deliver high-quality, high-efficiency audio amplification. This amplifier is configured with two BTL channels or one PBTL channel and the possibility to apply either a standard single-ended or a balanced (differential) analog input signal. Since channels are BTL (bridge tied load) bus pumping is never an issue with these amplifiers. The input section of the amplifier has two OPA1632 opamps... very high-performance, fully differential, audio operational amplifier designed to operate with single-ended or differential input signals (balanced). Output section features our custom made high performance inductors and metallized polypropylen capacitors. This is a very high quality power amplifier, and as always, made with the state-of-the-art materials and impeccable workmanship Class D Audio is known for. Small Size - 5.25" X 3.75" (133.35mm X 95.25mm) Click & Pop Noise Reduction Short Circuit and Thermal Protection Two Speed 12V Fan Output (most conditions will not require a fan) Sync Input Stereo or Bridged Configuration House Keeping Power Supplies Built-In... only requires one 20V to 50V power Supply

Model TI-600
Number Of Channels 2
RMS Power Per Channel 8 Ohms 135W RMS X 2
RMS Power Per Channel 4 Ohms 270W RMS X 2
RMS Power in Bridge Mode Up to 600W X1
Input Sensitivity 2V
Total Harmonic Distortion (THD) .02%
Frequency Response 10hZ to 45KHz
Input Impedance RCA 30K
Input Impedance XLR 30K
Voltage Gain for RCA Input 30
Voltage Gain for XLR Input 30
Power Requirements 24 Volts DC to 48 Volts DC
Dimensions (W x H x D) Inches 3.75 X 1.5 X 5.25
Dimensions (W x H x D) Millimeters 95.3 X 38.1 X 133.4
Product Weight (lbs/kg) 1.5/ 0.7
Shipping Weight (lbs/kg) 2.0/ 0.9
Manufacturer Class D Audio
Write Your Own Review
You're reviewing:TI-600 POWER AMPLIFIER MODULE
Your Rating